|
|
|
This is a mini Arduino based on-screen display board.
Its tailored for use with ArduPilot Mega and the MAVlink protocol, and designed to be as small as possible.
It main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader,
and a MAX7456 monochrome on-screen display. Programming is done through an FTDI-compatible 6-pin cable.
It features two independent power and ground sections to isolate the OSDs analog stage: a +5V section for the ATmega and th
|
|
|
|
|
The Arduino Sensor Shield V5.0 allows plug and play connection to various modules
like sensors, servos, relays, buttons, potentiometers and more.
Features:
I2C interface
Bluetooth module communication interface
SD card module communication interface
APC220 wireless RF modules communication interface
RB URF V1.1 ultrasonic sensors interface
12864 LCD serial and parallel interface
32 servo control
|
|
|
|
|
This new version of the ArduPilotMega 2.5 system features a newly designed enclosure and Power Module with integrated 5.3V regulator and current and voltage sensing.
The ArduPilot Mega 2.5 is a complete open source autopilot system and the bestselling technology that won the prestigious 2012 Outback Challenge UAV competition.This version is ready to use, with no assembly required.It allows the
|
|
|
|
|
The HKPilot Mega 2.5 is a complete open source autopilot system featuring the best selling technology. This version is ready to use, with no assembly required. It allows the user to turn any fixed wing, rotary wing or multi-rotor vehicle (even boats and car) into a fully autonomous vehicle capable of performing programmed GPS missions with waypoints (GPS module required - sold separately).
Feat
|
|
|
|
|
FY-901 je inerciální stabilizační systém pro multikoptéry. Díky současné instalaci tříosého gyroskopu a tříosého akcelerometru nabízí tato řídící deska pokročilé řešení "vše v jednom" pro velmi stabilní let jakékoliv multikoptéry!
FY-901 nabízí dva letové režimy, které mohou být přepínány pomocí RC soupravy i během letu:
Auto-stabilizační režim: V tomto režimu je využívaný tříosý akcelerometr pro autostabilizaci modelu tak, aby ramena multikoptéry byla vždy v jejich neutrální poloze. Tento režim je skvělý pro po
|
|
|
|
|
The NanoWii is a complete multi-rotor flight controller. It is based on the ATmega32U4, whichis the processor of the Arduino Leonardo and incorporates a MPU-6050 chip, which is a combinedgyro and accelerometer.
This is the ultimate solution for powerful flight performance with your multi-rotor project,especially micro size models. The possibilities are endless with the NanoWii,only limited by y
|
|
|
|
|
Pixhawk PX4 2.4.5 32 bit ARM Flight Controller & NEO-6M GPS/4G TF Card/Led External/PPM/PM Module/433 DTM for RC Multicopter
Description:
PIXHAWK intergrated the newest 32 bit chip technology and sensor technology, get rid of the dilemma of having only 8 bit CPU of APM, and CPU occupancy being too high
Features:
with external LED -Dual Size full angle LED
Advanced 32 bit ARM CortexM4 high pe
|
|
|
|
|
The Phantom 2 features the same compact, highly integrated design as the Phantom one, but comes with FPV flying and aerial cinematography support right out of the box. It is unbelievably easy to fly. Combined with smooth, stabilized footage from the optional H3-2D gimbal, aerial cinematography has never been easier. Its light, rugged and perfect for travel.
The Phantom 2 has an intelligent, hig
|
|
|
|
|
The MultiWii 328P is a gyro/accelerometer based flight controller that is loaded with features.
This version of the MultiWii supports DSM2 satellite receiver functionality.
With expandability options and full programmability, this device can control just about any type of aircraft.
This is the ideal flight controller for your multi-rotor aircraft.
Features:
• SMD component design with Atmega32
|
|
|
|
|
The Multiwii Lite V1.0 is a gyro/accelerometer based flight controller that is loaded with features.With expandability options and full programmability, this device can control just about anytype of aircraft. This is the ideal flight controller for your multi-rotor aircraft.
Features:
Small size, 35x35mm mounting holes
6 input channels for standard receiver and PPM SUM receiver
Up to 8-axis motor output
2 servos output for PITCH and ROLL gimbal system
Can utilize a servos outpu
|
|
|
|
|
KK2.0 byl navržen od základu tak, aby mohl létat s multicopterami každý.
Díky LCD obrazovce je instalace a nastavení jednodušší, než kdy jindy. Letové typy multi-copter jsou již předinstalovány. Jednoduše vyberete letový typ, zkontrolujete správné rozložení motorů, směr vrtulí, zkalibrujete a můžete letět!
Původní KK gyroskop je nahrazen neuvěřitelně citlivým dvojčipovým 3-osým gyroskopem a jednočipovým 3-osým akcelerometrem. Srdcem KK2.0 je Atmel Mega324PA 8-bit AVR RISC mikroprocesor s 32kB pamětí.
Do KK2.0 byly přidány
|
|
|
|
|
These self-adhesive foam mounting pads are the same as those sold by the big name brands but ata fraction of the price! This material is soft enough to provide excellent vibration dampening yet
rigid enough to keep your device from moving around. These properties make it the ideal choice for gyro,flybarless system and flight controller mounting. The materials used in these pads are sourceddirectly
|
|
|
|
|
For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M in a basic package offering a very competitive price. The innovative All-in-One design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller
|
|
|
|
|
The Multiwii SE V2.0 is a gyro/accelerometer based flight controller that is loaded with features.With expandability options and full programmability, this device can control just about anytype of aircraft. This is the ideal flight controller for your multi-rotor aircraft.
Features:
Small size, 35x35mm mounting holes
6 input channels for standard receiver and PPM SUM receiver
Up to 8-axis motor output
2 servos output for PITCH and ROLL gimbal system
Can utilize a servo output t
|
|
|
|
|
For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M in a basic package offering a very competitive price. The innovative All-in-One design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis
|
|
|
|