FlyCam Black32(Wii) Set + FlyCam GPS

FlyCam MultiCopter Controller " Black-32 " + FlyCam GPS

• Modern 32-bit ARM processor running at 3.3V/72MHz.
• 2000 degrees/second 3-axis MEMS gyro, accelerometer(MPU6050)
• 3-axis magnetometer (HMC5883L) and pressure sensor(MS5611).
• Support Quad-, Tri-, Hex-, Octo-, various coaxial configurations, as well
• As fully customizable motor mixer for any multicopter type.
• 8ch RC input-On board PPM convert for Standard, CCPM, Spektrum satellite, S.BUS
• Battery voltage monitoring and low voltage alarm.
• Modern 32-bit processor running at 3.3V/72Mhz
• FrSky telemetry transmission support. (on board converting circuit for FrSky receiver)
• MultiWii-based configuration software and GUI for easy setup
• Support SWD(Jtag) easy debug
• Open Source
• Easy connecting FLYCAM-GPS(ublox)
• Support FLYCAM OSD
• Extended SPI Port( it can be add SD-CARD or Optical Flow sensor by user)
• Extended I2C Port

• Acrobatic, Auto-level, Altitude hold ,Heading hold, Carefree( Basic flight mode)
• GPS position hold(optional, need GPS)
• Return to home(optional, need GPS)

• Dimension: 50 X 50 mm
• Mounting hole spacing: 45mm
• Hole diameter: 3mm
• Weight: 16 grams (All headers)

• FlyCam Black32(Wii) board
• USB to Serial
• Jumper cable (8 pieces)
• LED/Buzzer
• FlyCam GPS

WARNNING. Do not use this board for commercial aerial photography or the purpose which can be dangerous to the user is responsible for using.
WARNNING. the firmware is based on STM32 development environment and the AVR is not supported.