|
|
|
For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M in a basic package offering a very competitive price. The innovative All-in-One design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller
|
|
|
|
|
The Arduino Sensor Shield V5.0 allows plug and play connection to various modules
like sensors, servos, relays, buttons, potentiometers and more.
Features:
I2C interface
Bluetooth module communication interface
SD card module communication interface
APC220 wireless RF modules communication interface
RB URF V1.1 ultrasonic sensors interface
12864 LCD serial and parallel interface
32 servo control
|
|
|
|
|
Na základě popularity oblíbené KK řídící desky pro quadricoptéry, vychází i HobbyKing vstříc qudricoptérovému šílenství a nabízí svou řídící desku se skvělým poměrem ceny a kvality!
Základní deska pro quadricoptéru od HobbyKing je osazena piezo gyry od japonské firmy Murata, která jsou méně citlivá na otřesy, než standardní SMD gyra a u kterých způsob jejich výroby zajišťuje stálou kvalitu. Deska je dále osazena uživatelem programovatelným Atmega168PA procesorem.
Specifikace:
Rozměry: 50.5 mm x 50.5 mm x 23.5 mm
Hmotnost:
|
|
|
|
|
The HKPilot Mega 2.5 is a complete open source autopilot system featuring the best selling technology. This version is ready to use, with no assembly required. It allows the user to turn any fixed wing, rotary wing or multi-rotor vehicle (even boats and car) into a fully autonomous vehicle capable of performing programmed GPS missions with waypoints (GPS module required - sold separately).
Feat
|
|
|
|
|
The MultiWii PRO is a gyro/accelerometer based flight controller that is loaded with features.This version of the MultiWii supports direct connection of a GPS module (package includes MTK 3329 GPS module)allowing for ultra-precise positioning functionality.With expandability options and full programmability, this device can control just about any type of aircraft.This is the ideal flight controlle
|
|
|
|
|
FlyCam MCFC Sets
Specification:
FlyCam MCFC
FlyCam MCFC board
USB to Serial
Jumper cable (8 pieces)
LED/Buzzer
FlyCam GPS/Compass
FlyCam GPS/Compass board
External GPS module
100mm GPS module connecting cable x 2
Vibration Damper M3x15 (4 pieces)
PCB Support 50mm (4 pieces)
PCB Support 10mm (4 pieces)
|
|
|
|
|
This is a mini Arduino based on-screen display board.
Its tailored for use with ArduPilot Mega and the MAVlink protocol, and designed to be as small as possible.
It main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader,
and a MAX7456 monochrome on-screen display. Programming is done through an FTDI-compatible 6-pin cable.
It features two independent power and ground sections to isolate the OSDs analog stage: a +5V section for the ATmega and th
|
|
|
|
|
This new version of the ArduPilotMega 2.5 system features a newly designed enclosure and Power Module with integrated 5.3V regulator and current and voltage sensing.
The ArduPilot Mega 2.5 is a complete open source autopilot system and the bestselling technology that won the prestigious 2012 Outback Challenge UAV competition.This version is ready to use, with no assembly required.It allows the
|
|
|
|
|
Hobbyking i86L Multi-Rotor Control Board (Lite Edition) features the same level of stability and ease of setup as the standard i86. The i86L features a basic set of multi-rotor layouts and an easy ESC and and stick centering calibration mode via the dip switches.
Controlled by an Atmel Mega168PA 8-Bit RISC based micro controller and utilizing a single 3-axis MEMS gyro the Hobbyking i86L Multi-R
|
|
|
|
|
The Multiwii Lite V1.0 is a gyro/accelerometer based flight controller that is loaded with features.With expandability options and full programmability, this device can control just about anytype of aircraft. This is the ideal flight controller for your multi-rotor aircraft.
Features:
Small size, 35x35mm mounting holes
6 input channels for standard receiver and PPM SUM receiver
Up to 8-axis motor output
2 servos output for PITCH and ROLL gimbal system
Can utilize a servos outpu
|
|
|
|
|
The NanoWii is a complete multi-rotor flight controller. It is based on the ATmega32U4, whichis the processor of the Arduino Leonardo and incorporates a MPU-6050 chip, which is a combinedgyro and accelerometer.
This is the ultimate solution for powerful flight performance with your multi-rotor project,especially micro size models. The possibilities are endless with the NanoWii,only limited by y
|
|
|
|
|
For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M in a basic package offering a very competitive price. The innovative All-in-One design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis
|
|
|
|
|
The Multiwii SE V2.0 is a gyro/accelerometer based flight controller that is loaded with features.With expandability options and full programmability, this device can control just about anytype of aircraft. This is the ideal flight controller for your multi-rotor aircraft.
Features:
Small size, 35x35mm mounting holes
6 input channels for standard receiver and PPM SUM receiver
Up to 8-axis motor output
2 servos output for PITCH and ROLL gimbal system
Can utilize a servo output t
|
|
|
|
|
KK2.0 byl navržen od základu tak, aby mohl létat s multicopterami každý.
Díky LCD obrazovce je instalace a nastavení jednodušší, než kdy jindy. Letové typy multi-copter jsou již předinstalovány. Jednoduše vyberete letový typ, zkontrolujete správné rozložení motorů, směr vrtulí, zkalibrujete a můžete letět!
Původní KK gyroskop je nahrazen neuvěřitelně citlivým dvojčipovým 3-osým gyroskopem a jednočipovým 3-osým akcelerometrem. Srdcem KK2.0 je Atmel Mega324PA 8-bit AVR RISC mikroprocesor s 32kB pamětí.
Do KK2.0 byly přidány
|
|
|
|
|
The Phantom 2 features the same compact, highly integrated design as the Phantom one, but comes with FPV flying and aerial cinematography support right out of the box. It is unbelievably easy to fly. Combined with smooth, stabilized footage from the optional H3-2D gimbal, aerial cinematography has never been easier. Its light, rugged and perfect for travel.
The Phantom 2 has an intelligent, hig
|
|
|
|